MB

Indmar Marine Formed 1" 90° Hose | Part #841033 Maintain leak-free cooling System flow with this genuine Indmar 1 inch 90-degree formed hose. Pre-formed to the exact OEM shape, this hose fits perfectly first time — no bending, kinking, or makeshift modifications needed. Purpose-built for Indmar marine engines where precise hose routing in tight engine bays is critical. Compatible with: Indmar marine engines fitted to Malibu, Moomba, Supra, and Tige boats.

Indmar Marine Thermostat – 160° Ford 6.2L | Part #985901 Maintain optimal operating temperature in your Ford 6.2L marine engine with this genuine Indmar 160° thermostat. Purpose built for the Ford 6.2L — ensuring your engine reaches and holds the correct operating temperature quickly and consistently for maximum performance, fuel efficiency, and engine longevity on the water. Compatible with: Indmar Ford 6.2L marine engines fitted to Malibu, Moomba, Supra, and Tige boats. Contact us to verify fitment

Indmar Marine Ignition Coil – GM 1995 & Later | Part #556132 Restore strong reliable spark with this genuine Indmar ignition coil for GM-based Indmar marine engines 1995 and later. The ignition coil converts battery voltage into the high voltage spark energy needed to fire each cylinder — a failing coil means weak spark, misfires, and eventually a no-start condition on the water. Compatible with: Indmar GM marine engines 1995 and later fitted to Malibu, Moomba, Supra, and Tige boats.

Indmar Marine Heater Tube – Long | 6.2L | Part #597222 Maintain leak-free heater circuit connections on your Ford 6.2L with this genuine Indmar long heater tube. The companion piece to 597223 — correct OEM shape ensures perfect fitment first time with no modification required. Compatible with: Indmar Ford 6.2L marine engines fitted to Malibu, Moomba, Supra, and Tige boats. Contact us to verify fitment before ordering. Long or Short — which do I need? The 6.2L heater circuit uses two tubes — a short tube (597223) and a long tube (597222). One routes coolant to the heater and one returns it. If you are replacing one due to corrosion or damage it is strongly recommended to replace both at the same time — they wear at similar rates and replacing both together saves labour costs down the track.

Indmar Marine Fitting – 1/2" Male Brass x 1/2" Jiffy O-Ring Seal | Part #601048A Ensure a leak-free connection in your Indmar cooling or fluid system with this genuine Indmar 1/2" male brass fitting with Jiffy O-ring seal. Precision machined for correct OEM fitment — the O-ring seal design provides a positive leak-free connection without thread sealant or tape. Compatible with: Indmar marine engines and cooling systems fitted to Malibu, Moomba, Supra, and Tige boats.

Indmar Marine Raw Water Pump Bracket Kit – 5.7L | Part #495200 Ensure your raw water pump is correctly and securely mounted with this genuine Indmar raw water pump bracket kit for the 5.7L marine engine. The pump bracket is the structural foundation of your raw water cooling system — holding the pump in precise alignment with the drive belt and engine block. A worn, cracked, or incorrectly fitted bracket causes pump misalignment, accelerated belt wear, bearing failure, and ultimately cooling system breakdown on the water. Compatible with: Indmar 5.7L marine engines